Fence height and build
A tall solid fence, a gate or a different post type can need a different support detail. The post must leave the right height above ground as well as enough support below it.
Installation · UK fencing guidance
How deep
is enough?
There is no honest single number for every fence. Post depth depends on height, post length, ground, wind exposure, fence choice and the manufacturer’s instructions.
Depth, drainage and the concrete finish work together
The short answer
Depth is a site decision.
Not a magic number.
For many domestic timber panel fences, 450–600mm is a common starting range. Around 600mm is often used for a typical 1.8m / 6ft run, but the fence choice, ground and exposure still need checking.
Ground and exposure
Soft soil, rubble, slopes, waterlogged ground and wind exposure can change the sensible hole and post. A shallow figure should never be treated as a universal answer.
Drainage and treatment
Free-draining gravel or ballast, treated timber and the manufacturer’s instructions belong in the same decision. Drainage detail does not make an unsuitable or damaged post safe.
For many domestic timber panel fences, 450–600mm is a common starting range. Around 600mm is often used for a typical 1.8m / 6ft run, while soft, exposed, sloping or unstable ground may need a longer post and a deeper hole. A 1.5ft hole is not automatically wrong, but it is not a universal answer for a 1.8m fence.
Why the number
changes.
A tall, solid fence catches more wind than a low picket line. A heavy gate creates different forces again. Clay, loose topsoil, rubble, previous concrete, slopes and waterlogged ground can all change the support required. The post needs to be long enough to leave the correct height above ground and the correct support below it.
What goes at the bottom?
For timber posts set in concrete, follow the method specified for the post and fence you are installing. The Wood Protection Association guidance recommends 150 mm of gravel at the bottom of the hole. Jacksons’ post instructions give a separate detail for its products. These are examples for their stated methods, not one depth for every fence. Check the instructions supplied with your own post or fence.
In other words, gravel is not there to make a shallow hole appear deep. It is a drainable support layer and the amount depends on the method being used.
What happens around the post?
- Set out the line and post centres accurately so the panels, rails or gate will fit.
- Dig a suitable hole rather than forcing the post into hard ground and damaging its treatment.
- Use the specified free-draining gravel or ballast detail for the timber method.
- Position the post on the line and check it is plumb in both directions.
- Brace it while suitable postmix or concrete sets.
- Finish the top so water sheds away from the post, then check the line before fitting the final parts.
What about treated timber?
Pre-treated wood should not be casually reworked. The WPA advises avoiding modification where possible, protecting new cut surfaces with suitable end-grain preservative and using the treated/incised end in the ground as intended. A cross-cut end should not simply be buried because it has been painted.
Does every post need concrete?
No single method suits every site. Timber, concrete, metal supports, composite fences, walls, existing paving or concrete and retaining situations have different details. Follow the manufacturer’s instructions and get help if the boundary is tall, exposed, near services or structurally unusual.
Safety first: check the boundary and access rights, look for underground services, wear suitable PPE and do not dig near suspected cables or pipes without appropriate checks. If the ground or boundary is difficult to assess, ask an experienced installer to check it before digging.
See the detail
before you compare.
The installation standard shows the typical sequence and the visual difference between drainage, support and a rushed shortcut. For a live quote, send the postcode, height, rough length and photos of the ground at both ends.